Material models used in crash and impact simulation are only as good as the data behind them, and much of that data is still generated at slow, quasi-static loading rates. Andrea Incardona, application engineer and product specialist at high strain rate testing machine manufacturer Instron, argues in a company article that characterising materials at rates closer to real impact events gives engineers a more representative basis for simulation, material selection and product development.
Many materials show strain-rate-dependent behaviour: strength, stiffness, deformation mechanisms and failure behaviour can change as loading speed rises, so a material characterised under quasi-static conditions may respond differently in a rapid impact or crash. Instron cites a 2025 study in the SAE International Journal of Materials and Manufacturing, 'Influence of Strain Rate Effect on Mechanical and Crashworthiness Properties of CFRP Composite Structures', which found that incorporating strain-rate-dependent properties into crash simulations reduced the gap between simulation and experiment. According to the figures given, the discrepancy in peak acceleration fell by 6.5 per cent, while mean acceleration and displacement discrepancies fell by 5.9 per cent and 6.3 per cent respectively.
Test windows measured in milliseconds
Instron states that its high strain rate systems can characterise materials from quasi-static conditions up to strain rates approaching 1,000/s, a ceiling that depends on the material, specimen geometry and test method. Because such tests can last only 3 to 10 milliseconds, data acquisition must resolve very rapid changes in force and deformation. The company's systems support acquisition at up to 200 kHz, and digital image correlation (DIC) can add information on how strain develops across the specimen; analysis tools then support data processing and theoretical modelling.
Selection and development
Beyond simulation, dynamic characterisation is presented as a way to separate candidate materials that look comparable in conventional strength and stiffness testing. Where performance must be balanced against weight — automotive crash structures and aerospace components are the examples given — knowing how each material deforms, absorbs energy and ultimately fails under rapid loading adds a layer of information to the selection decision, alongside standard mechanical properties.
In development, Instron describes a loop in which material behaviour is measured, incorporated into simulation, used to compare design options and then validated through physical testing. Applied early, dynamic data can inform whether a material is suitable and how a component design might be refined, rather than serving only as a final check on an existing design.
The argument is essentially about relevance rather than volume: material data is useful to the extent that it reflects the conditions a component will actually face. The supporting figures come from a single published CFRP crashworthiness study and a supplier's account of its own test and acquisition capabilities, so engineers weighing the investment would still need to confirm that the strain rates and failure modes captured match their specific application.
