Industrial Machinery

WITT Gas Controls to Feature MEM+ Mixers and Safety Valves at FABTECH 2026

The Booth S46114 exhibit will focus on precision gas mixing, dome pressure regulation and protection against backflow and overpressure.

Maren OstergaardOctober 25, 20265 min read5 views

A stainless-steel gas mixing and pressure-control system with regulators and safety valves is shown in a bright industrial exhibition setting.

WITT Gas Controls plans to exhibit at FABTECH 2026, scheduled for October 21–23 at the Las Vegas Convention Center in Las Vegas, Nevada. At Booth S46114, the company will present its MEM+ gas mixers, dome pressure regulators and gas safety valves, with the exhibit centered on precise gas mixing, stable pressure and system protection.

The MEM+ series is designed to mix two or three non-flammable gases, including nitrogen, carbon dioxide and oxygen, for industrial applications. Electronically operated, motorized proportional valves adjust in 0.1 percent increments. According to WITT, the system can reach a desired mixture in less than three seconds, with accuracy better than ±1% absolute.

Control, monitoring and installation

Seven interface options, including Ethernet, OPC UA and PROFINET, support integration into existing systems. Operators can control the mixers remotely through a PC, PLC or machine controller, or directly through a touchscreen interface. The range of options is intended to let the mixer fit different plant control architectures rather than require a single operating setup.

Pressure equalization compensates for supply pressure fluctuations. Continuous inlet pressure monitoring and pressure alarms support safe, reliable operation, while an integrated buffer tank accommodates fluctuating flow rates. The MEM+ series is housed in a splash-proof, brushed stainless steel enclosure and supports maximum inlet pressures of 20 bar and maximum outlet pressures of 10 bar.

The combination places gas mixing, pressure compensation and flow buffering in a single enclosure. WITT presents these features as a way to support stable operation when supply conditions or demand change.

Pressure regulation and valve protection

WITT will also highlight dome pressure regulators that use optimized pilot pressure regulators. The design is intended to maintain stable working pressure despite changes in flow rates and inlet pressures. According to the company, this supports consistent process performance and product quality. The improvements can also be retrofitted to existing WITT dome pressure regulators without replacing the complete system, which may allow users to update current installations rather than replace the full regulator assembly.

The ULTRA non-return valves combine low opening pressures, tight sealing and minimal flow resistance to protect gas systems against unwanted backflow. ULTRAVENT safety relief valves provide protection against excessive pressure and respond to pressure increases as low as 5 mbar.

At FABTECH, WITT says attendees are invited to Booth S46114 to discuss the MEM+ mixers, dome pressure regulators and safety valves. The exhibit will bring together gas mixing, pressure control and protective components, reflecting the company's focus on gas safety, control and analysis solutions.